How to Connect and Program Your Schneider PLCs with TSXCUSB485 Driver 20
It has been tested to work with the TSXCUSB485 USB cable and the TSXPCX1031 RS232 cable.The RS232 cable is easier to work with as it does not require an additional driver like the USB cable does.
schneider tsxcusb485 driver 20
If the USB cable is NOT showing up correctly you may need an update Unitelway driver as it also contains the windows driver for the USB cable (Check for updates if it suddenly stops working, I will also try to post new drivers on the front of this blog).
The XIP driver is used to transfer program via ethernet to premium PLCs with an ethernet port onboard (For example TSX P573623A)This method is MUCH FASTER than via the serial cable.This step is OPTIONAL if you do not intend to program via an ethernet cable, you can skip this part.However, a valid ethernet configuration must already be on the PLC, meaning you cannot program an empty card with this method, for that you must still use the serial cable.Personally, I have a small program with just a hardware configuration that contains just an ethernet setup and nothing else.I download this to the PLC via the serial cable, and when the download is complete and the ethernet module is initialized, I download the large program via the ethernet cable.
Hello JavierThe guide is slightly outdated, there are new drivers that make it possible to use both the serial/usb cable and the XIP driver in windows 10:If you do not have access to the tscautomate.com website, the unitelway driver can be found here: øm.com/wp-content/uploads/2019/02/Unitelway_driver_7_2_2019-.zipand the XIP driver can be found here: øm.com/wp-content/uploads/2019/02/XIP-driver_7_2_2019.zip
I tried installing a more recent XIP driver, and the option disappeared from PL7.I then uninstalled the newer XIP driver from the drivers manager and rebooted.After that I tried to install XIP-driver_7_2_2019.zip again, and it was present in PL7 again.
This option requires basic OS understanding.Select Your Operating System, download zipped files, and then proceed tomanually install them.Recommended if Tsx C Usb 485 Com5 is the only driver on your PC you wish to update.
These drivers are usually included in the programming software on CD-ROM. And for the specific installation steps, please refer to the installation files on the CD-ROM drivers , and details are not necessary listed here.